E-mon E-MM-RTU-D-N User Manual download pdf (Page 53)

Chapter 4 Power Software Configuration tool

Remote Device Control

Multi-Mon Multiple Circuit Energy Monitor

2. Configure the list of parameters to be recorded in the data log file. See

Parameters for Data Monitoring and Logging in Appendix C for a list of

the available parameters.

3. Add the name for your data log file in the Name box. It will appear in the

data log reports.

4. Save your new setup to the device database, and send it to the meter.

5. Configure a setpoint for periodic triggering the Data recorder using the

MINUTE INTERVAL trigger (see Using Alarm/Control Setpoints).

Rem

RemRem

Remote Device Control

ote Device Controlote Device Control

ote Device Control

This section describes some online operations on the Multi-Mon you can

perform through Power Software. To access device control options you

should have your device online.

Viewing and Clearing Device Diagnostics

Viewing and Clearing Device DiagnosticsViewing and Clearing Device Diagnostics

Viewing and Clearing Device Diagnostics

To view or clear the device diagnostics status, check the On-line button on

the Power Software toolbar and select Device Control from the Monitor

menu.

Refer to Device Diagnostic Codes in Appendix F for the list of diagnostic

codes and their meanings. See Device Diagnostics in Chapter 2 for more

information on the Multi-Mon built-in diagnostics.

Click on the Clear button to clear the device diagnostics. You must be

connected to the Multi-Mon using the device base address to be able to

clear the diagnostics status.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 71 72

No comments

E-mon E-MM-RTU-D-N User Manual Page 53