E-mon E-MM-RTU-D-N User Manual download pdf (Page 29)

Chapter 3 Multi-Mon Display Operations

Menu Operations

Multi-Mon Multiple Circuit Energy Monitor

Viewing and Changing Setup Items

Viewing and Changing Setup ItemsViewing and Changing Setup Items

Viewing and Changing Setup Items

A second level menu normally consists of three items: the upper-left static

item indicates the menu name, while the upper-right item represents a list of

setup parameters you can scroll through, and the lower item shows the

present parameter value.

To select a parameter you want to view or change:

1. Highlight the upper-right item by briefly pressing the SELECT button if

the item is not highlighted yet.

2. Scroll through the parameter list with the UP/DOWN buttons until the

desired parameter name appears.

To change the selected parameter:

1. Press the SELECT button briefly to highlight the lower item.

2. If a number represents the parameter value, highlight a desired digit by

briefly pressing the SELECT button, then adjust the digit to the desired

value by the UP and DOWN buttons.

3. If a name represents the parameter value, select the desired value by

the UP and DOWN buttons.

4. Press the ENTER button to store your selection. You return to the

parameter list to select another parameter or return to the main menu.

To exit the menu:

1. Highlight the menu name (upper-left item) by pressing briefly the

SELECT button.

2. Press the ENTER button.

Menu Operations

Menu OperationsMenu Operations

Menu Operations

Submeter Channel Assignments

Submeter Channel AssignmentsSubmeter Channel Assignments

Submeter Channel Assignments

This menu allows you to link the device current terminals to submeters so

they can monitor them. Additionally, the menu allows you to specify the

primary current rating of the current transformers connected to the device

terminals. The number of the selected current inputs for a submeter specifies

if it will be a single-, two-, or three-phase meter.

Always select your submeters in a sequence without gaps so that your

Always select your submeters in a sequence without gaps so that your Always select your submeters in a sequence without gaps so that your

Always select your submeters in a sequence without gaps so that your

device does not occupy unnecessary network addresses.

device does not occupy unnecessary network addresses.device does not occupy unnecessary network addresses.

device does not occupy unnecessary network addresses.

To enter the menu, select the SubMeter entry from the main menu, and then

press the ENTER button.

To select a parameter you want to view or change:

1. Highlight the upper-right item by using the SELECT button.

2. Select the submeter you wish to configure with the UP/DOWN buttons.

3. Highlight the lower-left item by briefly pressing the SELECT button.

4. Scroll through the parameter list with the UP/DOWN buttons until the

desired parameter name appears.

To change the selected parameter:

1. Highlight the lower-right item by using the SELECT button.

COM1

Protocol

Modbus RTU

COM1

Address

SELECT

COM1 Address

001

COM1 Address

126

ENTER

COM1

Address

126

COM1 Exit

ENTER

























SubMeter

Exit

SubMeter

SM 1

Phase L1 I1

ENTER

SubMeter

SM 4

Phase L1 I1













SELECT

SubMeter SM 4

Phase L1 I1

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 71 72

Comments to this Manuals

No comments

E-mon E-MM-RTU-D-N User Manual Page 29

Comments to this Manuals

Related products and manuals for Accessories for electrical E-mon E-MM-RTU-D-N